Hello,
I am following through with the getting started guide, and I have reached the point where my yellow is supposed to connect to the site. It hasn’t yet, even though I have rebooted it and have a sim card installed (the sim card from my Mangoh red).
Any help would be greatly appreciated.
Thanks
Your Yellow comes with a SIM built into the module.
Please do not install external sim if you want to connect to Octave.
So do the following:
a. remove the external sim
b. Power cycle
c. Wait for around 30 mts
d. check website
e. you should see everything
f. then go update the yellow firmware available on the mangoh website.
It still hasn’t connected to the website. I powered it on and followed through the steps starting a little over three hours ago, and it wouldn’t connect. Around 2.5 hours in I attached the SIM card from my mangoh red.
cm data connect fails: LE_FAULT
do
a .cm radio
b. app status
post both the results.
root@swi-mdm9x28-wp:~# cm radio Power: ON Current Network Operator: Current RAT: Module not registered on network, RAT not available Status: Registration was denied, usually because of invalid access credentials (LE_MRC_REG_DENIED) Signal: No signal strength (0) PS: Packet Switched Not registered (LE_MRC_REG_NONE) root@swi-mdm9x28-wp:~# app status [running] NtagDhubIf [running] actions [running] atAirVantage [running] atQmiLinker [running] atService [running] audioService [running] avcService [running] battery [stopped] bluetoothSensorTag [running] button [running] buzzer [running] canopen [running] cellNetService [running] cloudInterface [running] dataConnectionService [running] dataHub [running] environment [running] fwupdateService [running] gpioService [running] helloYellow [running] imu [running] io [running] leds [running] light [running] location [running] modbus [running] modemService [stopped] ntag [running] portService [running] positioningService [running] powerMgr [running] qmiAirVantage [running] remote [running] secStore [stopped] spiService [stopped] tools [running] util [running] vegasMode [running] virtual [stopped] voiceCallService [stopped] wifi [stopped] wifiService root@swi-mdm9x28-wp:~#
Hi alexmanak
Maybe the module has no Cellular signal
https://mangoh.io/mangoh-yellow-resources-getting-started gives a link to
the “mangOH Yellow Getting Started Guide”
In particular section 3: Set Up Your mangOH Yellow - the switch settings and external antenna connection
Also do you have general cellular connectivity at the location where the yellow is being used?
I am seeing very similar results here. the tools app seems to be crashing and cm radio shows the device hooping form one network provider to another trying to register. I am in canada and see it connect to Rogers and Bell at various times with a signal strength of 5. but registration is never successful. i have had it powered with, with a battery, and an external antenna connected and selected for 3 days with no success.
there was an issue with our backend server. This has since been resolved.
@alexmanak can you let community know you issue is solved?
@tlistoe please me a private message with IMEI, FSN, ID and company name? I will ask the backend team to fix it.
Hi Ashish, how are you?
How you’ve solved the issue ?
I have the same problem. I’m wondering if my mangoh yellow (from the SW innovation summit) had expired the “trial” period maybe… ?
Because the last time I used the board (09-December) it worked propperly. Now is not attaching any network, nor connecting to Octave.
Thanks,
Diego.
@asyal i have another module that was purchased at the same time that we are brining online which has the same problem. I have DMd you the details you requested before for this module if you could please activate it as well?
replied in private chat to get this going.
Hello
Please help me to troubleshoot a similar problem with connecting my MangOH Yellow to Octave cloud.
The device was not used since 04.12.2019, it has an external SIM card inserted.
root@swi-mdm9x28-wp:~# cm data
Index: 1
APN: iot.swir
PDP Type: IPV4V6
Connected: no
root@swi-mdm9x28-wp:~# cm radio
Power: ON
Current Network Operator: Sierra Wireless
Current RAT: Module not registered on network, RAT not available
Status: Not registered but currently searching for a new operator (LE_MRC_REG_SEARCHING)
Signal: Good signal strength (3)
PS: Packet Switched Not registered (LE_MRC_REG_NONE)
root@swi-mdm9x28-wp:~# cm sim
SIM card is inserted and unlocked (LE_SIM_READY).
root@swi-mdm9x28-wp:~# cm sim info
Type: EMBEDDED
ICCID: 89332401000010872709
Home Network Operator: Sierra Wireless
EID: 89033240817620069918070003394789
IMSI: 206018032639816
Phone Number:
root@swi-mdm9x28-wp:~# app status
[running] NtagDhubIf
[running] actions
[running] atAirVantage
[running] atQmiLinker
[running] atService
[running] audioService
[running] avcService
[running] battery
[stopped] bluetoothSensorTag
[running] bluetoothServices
[running] button
[running] buzzer
[running] canopen
[running] cellNetService
[running] cloudInterface
[running] dataConnectionService
[running] dataHub
[running] diagnostic
[running] environment
[running] fwupdateService
[running] gpioService
[running] helloYellow
[running] imu
[running] io
[running] leds
[running] light
[running] location
[running] modbus
[running] modemService
[stopped] ntag
[running] orp
[running] portService
[running] positioningService
[running] powerMgr
[running] qmiAirVantage
[running] secStore
[stopped] smsInboxService
[stopped] spiService
[stopped] tools
[running] usp
[running] util
[running] vegasMode
[running] virtual
[stopped] voiceCallService
[stopped] wifi
[running] wifiService
root@swi-mdm9x28-wp:~# cm data connect
Setting up profile 1
Connecting … failed
Sun Jan 6 02:20:52 +02 1980 - Connection Failure: LE_FAULT
Seems to be an APN issue.
You can see here
You can try “app stop cloudInterface” and then set the APN by “cm data apn xxx”
