micro-SD card does not work on mangOH Red

mangOH Red
1

I tried to install 2 different SanDisk cards: 16GB and 8GB.
Both the cards do not work.

[ 9.456279] mmc0: mci-version: 18
[ 9.465557] mmc0: bam physical base=0x12182000
[ 9.469006] mmc0: bam virtual base=0xd01fc000
[ 9.485457] mmc0: BAM device registered. bam_handle=0xce5cba00<6>[ 9.490645] sps:REVISION of BAM 0xd01fc000 is 0x5.
[ 9.503860] mmc0: Qualcomm MSM SDCC-BAM at 0x0000000012182000 irq 130
[ 9.509446] mmc0: Qualcomm MSM SDCC-DML at 0x0000000012180800
[ 9.515061] mmc0: No card detect facilities available
[ 9.524370] mmc0: Qualcomm MSM SDCC-core at 0x0000000012180000 irq 136,0 dma -1 dmacrcri -1
[ 9.545704] mmc0: 8 bit data mode disabled
[ 9.548786] mmc0: 4 bit data mode enabled
[ 9.552784] mmc0: polling status mode disabled
[ 9.562887] mmc0: MMC clock 400000 -> 48000000 Hz, PCLK 0 Hz
[ 9.591362] mmc0: Slot eject status = 0
[ 9.604669] mmc0: Power save feature enable = 1
[ 9.613734] mmc0: SPS-BAM data transfer mode available
[ 9.783091] mmc0: msmsdcc_switch_io_voltage: MCIDATIN_3_0 are still not all ones
[ 10.144391] mmc0: mmc_sd_init_card() failure (err = -110)
[ 10.155653] mmc0: error -110 whilst initialising SD card

What can cause problems ?

2

Did you install the SD cards before powering up the unit? I think there is a limitation that prevents hotplug from working.

3

I have powered the board after the card had been inserted

4

@dfrey So there i no way to detect the SD card if u insert it after power up?

5

Yes, this is not a mangoh red thing but the module doesn’t allow you to do that