I want to send and receive data from WP7702 via a serial interface from an external processor. Without to have to do any changes in the Legato code. I want to use the WP7702 as a radio module only and configure it with help of AT commands. Is that possible or do I have to do changes in the Legato c…

[image] Need Information On UART mangOH Green Hello @dfrey , I was attempting to get into the UART and found your post. I tried to follow your instructions but what was returned was “-sh: mircom: not found” I tried sudo… "sudo: not found: apt-get… "apt-get: not found An…

Thats ok to use. Just set the UART into AT mode. You can use the at mode even after you go past the mangoh stage

Thanks for the info asyal. That raises more questions: Were can I read more about setting the UART-mode? Do I have to set the UART-mode after each time the WP7702 is powered off? /Lars

Access WP7702 from external processor via serial interface?

mangOH Red

asyal December 4, 2018, 5:51am 4

or https://source.sierrawireless.com/resources/legato/howtos/customizeuart/
should help

Topic		Replies	Views
WP7700 AT command Interface over UART using MangOH Red mangOH Red	7	1999	September 18, 2020
[SOLVED] WP7702 AT command interface over UART on mangOH Red mangOH Red Orange Starter Kit	0	919	November 20, 2018
AT!MAPUART strange behavior mangOH Green	17	1768	September 26, 2018
WP7702 AT command interface over UART (header raspberry) on mangOH Red with external microcontroller mangOH Red	0	591	November 22, 2018
Serial with wp7607 mangOH Red	2	1683	April 25, 2019

Access WP7702 from external processor via serial interface?

Related topics